 Apple Technician Guide MacBook Pro (15-inch, Mid ... - tim.id.au

Removal
1 Place tape over
battery button on
outside of top case
to prevent losing the
button.
2 Remove 3 (1.8 mm)
922-9069 screws.
3 Using a black stick,
pry back the EMI
spring shield to
access the BIL cable.
Note: If replacing the
BIL board, discard
the bent EMI spring
shield. Install new
shield that came with
BIL assembly.
4 Peel the cable off the
top housing.
Replacement Note:
Before replacing the BIL
board, check that:
• the long rubber gasket
is assembled on top of
the LEDs
• the BIL button is
installed in the top
case
• the EMI spring shield is
installed
2010-08-05
MacBook Pro (15-inch, Mid 2010) Take Apart — Battery Indicator Light Cable and Board 189