 Apple Technician Guide MacBook Pro (15-inch, Mid ... - tim.id.au

More documents

Recommendations

Info

4 Remove 2 (1.2 mm) 922-9037 screws, and remove cable cover. 5 Caution: Referring to “Connector Types,” carefully disconnect 8 more cables in the order shown: (1) keyboard backlight (2) camera cable (3) optical drive (4) right speaker (5) hard drive/IR/sleep (6) trackpad flex (7) keyboard (8) battery indicator 2010-08-05 MacBook Pro (15-inch, Mid 2010) Take Apart — Logic Board 170
6 Remove 7 (3.0 mm) 922-9108 Torx T6 screws. 7 Pull board away from ports. 8 Tilt board vertically and on the underside disconnect the magsafe board cable. 9 Lift logic board from top case. Note: Do not remove the left speaker, microphone, and heatsink if reinstalling the same logic board. Replacement Note: If replacing the logic board with a new one, transfer the following: • left speaker • microphone • heatsink • left fan 2010-08-05 MacBook Pro (15-inch, Mid 2010) Take Apart — Logic Board 171
Page 1 and 2:
apple Apple Technician Guide MacBoo
Page 3 and 4:
MacBook Pro (15-inch, Mid 2010) Con
Page 5 and 6:
Built-in Trackpad Does Not Work 90
Page 7 and 8:
Views Exploded Views 196 Main Assem
Page 9 and 10:
2008-10-19 Manual Updates Update 11
Page 11 and 12:
apple Apple Technician Guide Basics
Page 13 and 14:
2010-08-05 Battery Precaution and T
Page 15 and 16:
2010-08-05 Serial Number Location S
Page 17 and 18:
apple Apple Technician Guide Troubl
Page 19 and 20:
2010-08-05 Hardware vs. Software Fo
Page 21 and 22:
2010-08-05 Block Diagram Refer to t
Page 23 and 24:
2010-08-05 Resetting the Parameter
Page 25 and 26:
2010-08-05 Symptom Charts Follow th
Page 27 and 28:
2010-08-05 7. Inspect MagSafe port
Page 29 and 30:
2010-08-05 4. Hold the Alt (Option)
Page 31 and 32:
2010-08-05 User-related shutdowns A
Page 33 and 34:
2010-08-05 2. Booting from known-go
Page 35 and 36:
2010-08-05 No Video/Bad Video Unlik
Page 37 and 38:
2010-08-05 9. Check for No Backligh
Page 39 and 40:
2010-08-05 5. Verify if battery sta
Page 41 and 42:
2010-08-05 Kernel Panic/System Cras
Page 43 and 44:
2010-08-05 6. Disconnect display as
Page 45 and 46:
2010-08-05 Power Adapter Issue Unli
Page 47 and 48:
2010-08-05 3. Disconnect any periph
Page 49 and 50:
2010-08-05 Battery Leaking or Swoll
Page 51 and 52:
2010-08-05 3. Verify if IP address
Page 53 and 54:
2010-08-05 Deep Dive Check Result A
Page 55 and 56:
2010-08-05 No/Poor Wireless Signal
Page 57 and 58:
2010-08-05 Bluetooth Wireless Input
Page 59 and 60:
2010-08-05 AirPort Card: Kernel Pan
Page 61 and 62:
2010-08-05 2. Turn off Bluetooth. R
Page 63 and 64:
2010-08-05 5. Verify if Bluetooth a
Page 65 and 66:
2010-08-05 Deep Dive: Incorrect/Mis
Page 67 and 68:
2010-08-05 Deep Dive: Vertical/Hori
Page 69 and 70:
2010-08-05 Defective Camera / Built
Page 71 and 72:
2010-08-05 6. Substitute with a kno
Page 73 and 74:
2010-08-05 Noise / Unstable Flicker
Page 75 and 76:
2010-08-05 Mass Storage Hard Drive
Page 77 and 78:
Page 79 and 80:
2010-08-05 5. After installing new
Page 81 and 82:
2010-08-05 7. Verify if optical med
Page 83 and 84:
Page 85 and 86:
2010-08-05 7. Disc spin should ceas
Page 87 and 88:
2010-08-05 Input/Output Devices USB
Page 89 and 90:
2010-08-05 4. Reseat cable and chec
Page 91 and 92:
2010-08-05 7. Verify if a known-goo
Page 93 and 94:
2010-08-05 Built-in Keyboard Is Not
Page 95 and 96:
2010-08-05 5. Verify if the trackpa
Page 97 and 98:
2010-08-05 2. Play some music and p
Page 99 and 100:
2010-08-05 Audio: Microphone Unlike
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
2010-08-05 Mechanical Issues: Therm
Page 107 and 108:
2010-08-05 System Runs Hot Unlikely
Page 109 and 110:
apple Apple Technician Guide Take A
Page 111 and 112:
Horizontal Install • Pull connect
Page 113 and 114:
Battery Precaution This computer co
Page 115 and 116:
First Steps Warning: • Shut down
Page 117 and 118:
2 Remove 10 screws: • 3 (14 mm) 9
Page 119 and 120: First Steps Remove: • Bottom case
Page 121 and 122: 3 Using a black stick, pry cable fr
Page 125 and 126: 3 Use pull tab to tilt hard drive o
Page 127 and 128: Replacement 1 Touch a metal surface
Page 129 and 130: 2010-08-05 Reinstalling Software Th
Page 131 and 132: Removal 1 Caution: The cable is fra
Page 133 and 134: Memory Information Memory cards mus
Page 139 and 140: 2 Remove 2 screws: • 1 (8.1 mm) 9
Page 141 and 142: 6 If you are removing card holder f
Page 143 and 144: First Steps Do the following: • R
Page 149 and 150: Replacement Note: Be sure grounding
Page 151 and 152: Removal 1 Remove 6.5 mm (922-8645)
Page 155 and 156: 4 Open the display to 90 degrees, a
Page 157 and 158: Removal 1 Cover display face with c
Page 159 and 160: 3 Position clutch cover onto end wi
Page 161 and 162: Removal 1 Using black stick, discon
Page 163 and 164: Reassembly Note: Inspect the top an
Page 165 and 166: Removal 1 Use a black stick to disc
Page 167 and 168: Removal 1 Use a black stick to pry
Page 169: Removal Caution: The LVDS cable/ lo
Page 175 and 176: Replacement Important: New heatsink
Page 177 and 178: Removal 1 Carefully peel up trackpa
Page 179 and 180: Replacement 1 Route flex cable thro
Page 181 and 182: 6 Turn top case over. Tighten screw
Page 183 and 184: Removal 1 Carefully peel back tape
Page 185 and 186: Removal Use black stick to pry micr
Page 187 and 188: Removal 1 Remove 2 (7.5 mm) 922-904
Page 189 and 190: Removal 1 Place tape over battery b
Page 191 and 192: Removal 1 Remove 2 screws: • 1 (9
Page 193 and 194: Removal With the first steps comple
Page 195 and 196: apple Apple Technician Guide Views
Page 197 and 198: 2010-08-05 Main Assembly 2 Bottom C
Page 199 and 200: 2010-08-05 External Views Front Vie
Page 201 and 202: Bottom Case 3 (14 mm) 922-8985 7 (3
Page 203 and 204: AirPort/Bluetooth Card Holder 1 (8.
Page 205 and 206: Display Assembly 6 (5.3 mm) 922-864
Page 207 and 208: Heatsink 6 (8 mm) 922-9328 Torx T6
Page 209 and 210: Battery Indicator Light Board 3 (1.
Page 211: 2008-08-27 922-9094 Phillips #00 Ri
show all

 Apple Technician Guide MacBook Pro (15-inch, Mid ... - tim.id.au

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?