Properties of hemp fibre polymer composites -An optimisation of ...

More documents

Recommendations

Info

Lilholt, H., 2002. Strength of cellulose and fibres. In: Lilholt, H., Madsen, B., Toftegaard, H., Cendre, E., Megnis, M., Mikkelsen, L.P., Sørensen, B.F. (Ed.), Sustainable natural and polymeric composites - science and technology. Proceedings of the 23th Risø International Symposium on Materials Science, Risø National Laboratory. Denmark. pp. 225-230. Lilholt, H., Lawther, J.M., 2000. Natural organic fibres. Elsevier. In: Kelly, A. and Zweben, C. (Ed.), Comprehensive composite materials, vol. 1, pp. 303-325. Madsen, B., 2004. Properties of plant fibre yarn polymer composites - An experimental study. Ph.D. thesis, BYG-DTU, Technical University of Denmark, ISBN 87-7877-145-5. Madsen, B., Lilholt, H., 2003. Physical and mechanical properties of unidirectional plant fibre composites - an evaluation of the influence of porosity. Compos. Sci. and Technol. 63, 1265-1272. Madsen, F.T., Burgert, I., Jungnikl, K., Felby, C., Thomsen, A.B., 2003. Effect of enzyme treatment and steam explosion on tensile properties of single hemp fiber. In: 12th International Symposium on Wood and Pulping Chemistry (ISWPC), Madison, P80. Meijer, W.J.M., Vertregt, N., Rutgers, B., van de Waart, M., 1995. The pectin content as a measure of the retting and rettability of flax. Ind. Crops Prod. 4, 273- 284. Mieck, K.-P, Lützkendorf, R., Reussmann, T., 1996. Needle-punched hybrid nonwovens of flax and PP fibers -textile semiproducts for manufacturing of fiber composites. Polym. Compos. 17, 873-878. Morvan, C., Jauneau, A., Flaman, A., Millet, J., Demarty, M., 1990. Degradation of flax polysaccharides with purified endo-polygalacturonase. Carbohydr. Polym. 13, 149-163. Nishiyama, Y., Langan, P., Chanzy, H. 2002. Crystal structure and hydrogenbonding system in cellulose Iβ from synchrotron X-ray and neutron fiber diffraction. J. Am. Chem. Soc. 124, 9074-9082. Nyhlen, L., Nilsson, T., 1987. Combined T.E.M. and UV-microscopy on delignification of pine wood by Phlebia radiata and four other white rotters. In: Odier, E. (Ed.), Proc. of Lignin Enzymic and Microbial Degradation Symposium, INRA Publications, pp. 277-282. Obrien, R.N., Hartman, K., 1971. Air infrared spectroscopy study of epoxy-cellulose interface. J. Polym. Sci. Part C-Polym. Symp. 34, 293. Page, D.H., El-Hosseiny, F., Winkler, K., and Lancaster, A.P.S., 1977. Elastic modulus of single wood pulp fibers. Tappi 60, 114-117. Rosember, J.A., 1965. Bacteria responsible for retting of Brazilian flax. Appl. Microbiol. 13, 991-992. Thomsen, A.B., Rasmussen, S., Bohn, V., Nielsen, K.V., Thygesen, A., 2005. Hemp raw materials: The effect of cultivar, growth conditions and pretreatment on the chemical composition of the fibres. R-1507, Risø National Laboratory, Denmark. 142 Risø-PhD-11
Thygesen, A., 2006. Properties of hemp fibre polymer composites - An optimisation of fibre properties using novel defibration methods and detailed fibre characterisation. Risø-PhD-11(EN), Risø National Laboratory, Denmark. Thygesen, A., Daniel, G., Lilholt, H., Thomsen, A.B., 2005a. Hemp fiber microstructure and use of fungal defibration to obtain fibers for composite materials. J. Nat. fibres 2, 19-37. Thygesen, A., Madsen, F.T., Lilholt, H, Felby, C., Thomsen, A.B., 2002. Changes in chemical composition, degree of crystallisation and polymerisation of cellulose in hemp fibres caused by pre-treatment. In: Lilholt, H., Madsen, B., Toftegaard, H., Cendre, E., Megnis, M., Mikkelsen, L.P., Sørensen, B.F. (Ed.), Sustainable natural and polymeric composites - science and technology. Proceedings of the 23th Risø International Symposium on Materials Science, Risø National Laboratory. Denmark, pp. 315-323. Thygesen, A., Oddershede, J., Lilholt, H., Thomsen, A.B., Ståhl, K., 2005b. On the determination of crystallinity and cellulose content in plant fibres. Cellulose 12, 563-576. Toftegaard, H. and Lilholt, H., 2002. Effective stiffness and strength of flax fibres derived from short fibre laminates. In: Lilholt, H., Madsen, B., Toftegaard, H., Cendre, E., Megnis, M., Mikkelsen, L.P., Sørensen, B.F. (Ed.), Sustainable natural and polymeric composites - science and technology. Proceedings of the 23th Risø International Symposium on Materials Science, Risø National Laboratory. Denmark, pp. 325-334. Risø-PhD-11 143
Page 1 and 2:
Risø-PhD-11(EN) Properties of hemp
Page 3 and 4:
Contents Preface 6 1 Resumé 7 2 Li
Page 5 and 6:
PhD thesis: Properties of hemp fibr
Page 7 and 8:
1 Resumé Karakterisering af hampef
Page 9 and 10:
2.4 Oral presentations Anders Thyge
Page 11 and 12:
4 Introduction Hemp (Cannabis sativ
Page 13 and 14:
4.2 The outline of the thesis The f
Page 15 and 16:
The only fertilizer used was 360/48
Page 17 and 18:
Temperature [ o C] 35 30 25 20 15 1
Page 19 and 20:
A B Figure 7. A: Model of transvers
Page 21 and 22:
Figure 8. Lignin (a), pectin (b) an
Page 23 and 24:
Figure 11. Microfibril angles (MFA)
Page 25 and 26:
Teleman, 1997). The crystal structu
Page 27 and 28:
to the computing effort and the sub
Page 29 and 30:
Figure 15. The structure of hemicel
Page 31 and 32:
fibre mats, which are made by air-d
Page 33 and 34:
Figure 18. From fibre filament to a
Page 35 and 36:
A B C D Figure 20. Chemical structu
Page 37 and 38:
water vapour and air are removed fr
Page 39 and 40:
7 Defibration methods Defibration m
Page 41 and 42:
Table 5. Fibre yield and cellulose
Page 43 and 44:
a b c Composition [% w/w] 100 Compo
Page 45 and 46:
8 Fibre strength in hemp The streng
Page 47 and 48:
8.2 Effect of pre-treatment of hemp
Page 49 and 50:
E-modulus [GPa] 90 80 70 60 50 40 3
Page 51 and 52:
Second mode: Failure is controlled
Page 53 and 54:
structure, which made much higher f
Page 55 and 56:
Table 7. Porosity factors determine
Page 57 and 58:
Thereby, the effective fibre streng
Page 59 and 60:
a b Composite tensile strength σcu
Page 61 and 62:
Table 9. Mechanical properties in a
Page 63 and 64:
a σ c/ρ c [10 3 m 2 /s 2 ] b Ec/
Page 65 and 66:
Fibre strength σ f [MPa] Fibre sti
Page 67 and 68:
11 References Andersen TL, Lilholt
Page 69 and 70:
Kaar WE, Cool LG, Merriman MM, Brin
Page 71 and 72:
Stowell EZ, Liu TS, 1961. On the Me
Page 73 and 74:
Appendix A: Comprehensive composite
Page 75 and 76:
The porosity constants can now be d
Page 77 and 78:
Appendix D: Density and mechanical
Page 79 and 80:
Paper I Changes in chemical composi
Page 81 and 82:
Risø-PhD-11 81
Page 83 and 84:
Risø-PhD-11 83
Page 85 and 86:
Risø-PhD-11 85
Page 87 and 88:
Risø-PhD-11 87
Page 89 and 90:
Paper II Hemp fiber microstructure
Page 91 and 92: ABSTRACT Characterization of hemp f
Page 93 and 94: METHODS AND TECHNIQUES Treatment of
Page 95 and 96: 2000) and their orientation gave th
Page 97 and 98: By TEM microscopy, the single fiber
Page 99 and 100: Table 1. Chemical composition of th
Page 101 and 102: Table 2. Tensile strength (σ) and
Page 103 and 104: Morvan, C., Jauneau, A., Flaman, A.
Page 105 and 106: Risø-PhD-11 105
Page 119 and 120: Paper IV Comparison of composites m
Page 121 and 122: ABSTRACT Aligned epoxy-matrix compo
Page 123 and 124: the calculation of volume fractions
Page 125 and 126: solution (pH 4) for 4 h at 85°C. L
Page 127 and 128: E ⎛ dσ c ⎞ = ⎜ ⎟ ⎝ dε
Page 129 and 130: Table 2. Chemical composition, stru
Page 131 and 132: transverse section of the small hem
Page 133 and 134: Long fibres that pass through the e
Page 135 and 136: Figure 6. Effect of composite fabri
Page 137 and 138: DISCUSSION The defibration of hemp
Page 139 and 140: This investigation showed that the
Page 141: Bos, H.L., Molenveld, K., Teunissen
Page 147: Risø’s research is aimed at solv
show all

Properties of hemp fibre polymer composites -An optimisation of ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?