Rack Palette - Operators Manual - Strand Lighting

Programming and Viewing Channels
[1] [THRU] [10] [-] [5]
[THRU] ][8] [ENTER]
[1] [SHIFT] [THRU]
[100] [ENTER]
[1] [NEXT] [NEXT]
[NEXT]
[4] [PREV] [PREV]
[PREV]
Selects Channels 1 through 4 and 9 and 10
Selects any Channel with an intensity greater
than 0% between Channels 1 and 100 (thru-on)
Selects Channels 1 through 4
Selects Channels 1 through 4
After selecting Channels, you can roll the Wheel to adjust the level. If you hold down
[SHIFT] while rolling the wheel, the level will change in finer steps (for example,
when changing 8-bit intensities, it will change in decimal steps from 0 to 255, but in
other cases it may be different). It is also important to know the order in which you
select Channels is preserved when recording group which makes a big difference
for Fanning and Effects.
Setting Levels
You can set levels before or after you press [ENTER]. By default, Intensity Levels
are depicted in percent. They can also be entered in Decimal if you precede the
value by the decimal point [.].
[1] [@] [55]
[ENTER]
[1] [@] [50]
[ENTER]
[1] [@] [5]
[ENTER]
[1] [@] [05]
[ENTER]
[1] [@] [.] [127]
[ENTER]
[1] [@] [FULL]
[ENTER]
Selects Channel 1 and sets it to
55%
Selects Channel 1 and sets it to
50%
Selects Channel 1 and sets it to
50% (Note: after typing an [@],
you don't need the zero in 50)
Selects Channel 1 and sets it to
5%
Selects Channel 1 and sets it to
50% or 127 Decimal (Note: the
[.] key puts the word Decimal
on the command line)
Selects Channel 1 and sets it to
100%
[1] [@] [FULL] Selects Channel 1 and sets it to
100%
[1] [@] [@] Selects Channel 1 and sets it to
100%
[1] [FULL] Selects Channel 1 and sets it to
100%
[1] [OUT] Selects Channel 1 and sets it to
0%
[1] [SHIFT] [THRU] Selects any Channel that has a
Palette OS Operations Manual 100