Rack Palette - Operators Manual - Strand Lighting

Tools
Channel Check
With Channel Check, you can easily accomplish your pre-show lighting check. Your
Channel Check can be done either manually or automatically.
To Manually Perform A Channel Check
1. Select the Channel where you want to start the Channel check.
2. Press and hold the Tools Button or [T] on the QWERTY
keyboard.
3. Select Channel Check [S1].(you may need to select to
see Channel Check on [S1]).
4. The Current Channel text box will have the first Channel you have
selected in it. Change it with the Wheel or by typing in a new number
if needed.
Note:
If you type a value in the Current Channel box and press Enter, the
Channel will raise to the High Check Value. If you then type in a new
number and press Enter again, the previous number will go to the Low
Check Value and the new Channel will go to the High Check Value.
5. Select the High Check Value box and enter a percentage level to
establish the maximum level at which Channels play during the
check.
6. Select the Low Check Value box and enter a percentage level to
establish the minimum level Channels return to after being checked.
7. Use the Go Forward or Go Back button to manually execute each
step of the Channel Check.
8. Click OK when the check is completed.
9. Click the Release button on the Channel grid toolbar twice (or press
the [REL] key twice) to release all Channels controlled by the keypad
(shown with red levels under the Channel number).
To Automate Channel Check
1. Follow steps 1 through 6 above.
2. Enter a time in the Advance Time text box.
Note:
227 Palette OS Operations Manual