Rack Palette - Operators Manual - Strand Lighting

Programming and Viewing Channels
Load
Loading Cues and Sub Masters is the most effective method of examining, changing
and updating the stored data.
Updating a Cue from the LIVE Display using Load
1. Select from the channel grid Tool Bar .
2. Press [LOAD], enter a cue number. The QWERTY equivalent
to hitting [LOAD] is [SHIFT][B] (Load is Shift Blind).
Note:
The Cue Number box is active when you enter this dialog. If you roll the
wheel you can scroll through the list to select a cue. The Cue Number is prestuffed
with the cue number where the Blue Box was sitting, so it is fastest to
move the Blue Box to the cue you want to load before pressing [Load].
3. If desired press [S5] to load the cue's State or the cumulative
effect of all cues up to that point in the cue list as hard values.
4. Press [ENTER] to load the Cue.
5. Note the Loaded Status Bubble shows which cue is loaded.
The Cue List is on the top line and the cue number (or label if
set) is below.
Note:
The first item you Load gets shown in the Loaded Status Bubble. If you do
subsequent loads (essentially layering ideas), then press [UPDT], the item
shown in the Loaded Bubble is the one that gets Updated. In the LIVE
display, loading multiple things does not clear what is loaded automatically.
Check to see if the Loaded Bubble is clear first. To clear it, press [REL] or
[ESC] until it is clear.
Palette OS Operations Manual 144