Rack Palette - Operators Manual - Strand Lighting

Recording and Editing Cues
6. Make the changes to the cue as necessary. You can remove or
'knock out' Channels from a cue by selecting them and hitting
[REL] or [ESC]. See the Release topic for methods of
releasing individual attributes.
7. Press [UPDT] or [U] to update the cue. The Captured
channels will be released and the Loaded Status Bubble will
be cleared. If the loaded cue is the active cue, the stage will
not change. If the loaded cue is prior to the active cue, the
changes will fade when you hit [GO]. If the loaded cue is after
the current cue, when you press [UPDT] the channels will be
release immediately and return to their proper levels as
determined by the console's Fade Resolution.
Note:
[S9] - Opens the Attribute dialog box to allow you to filter what will
be loaded:
o
o
If you double tap [S5] (or any other softkey), it will 'solo' Position.
That is, all other check marks will clear and Position will remain
checked.
While in the main Load dialog box, if you press [SHIFT], the
Attribute button will look like this
change to the following:
and the softkeys will
Pressing any of these changes the attribute masking without the need to
open the Attribute dialog box. You can also double tap any attribute family to
solo it.
o If you do any Attribute Masking during the load process,
the Loaded Status Bubble will not be filled and you will not be able
to use [UPDT]. You will have to use [REC] and specifically
determine where you are going to record what was loaded.
Updating a Cue from the BLIND Display using Load
1. Select from the channel grid Tool Bar .
2. Press [LOAD], enter a cue number. The QWERTY equivalent to
hitting [LOAD] is [SHIFT][B] (Load is Shift Blind).
145 Palette OS Operations Manual