Rack Palette - Operators Manual - Strand Lighting

Programming and Viewing Channels
[10] [@] [5]
[ENTER]
[1] [@] [+] [50]
[ENTER]
[1] [THRU] [10]
[@] [-] [5] [ENTER]
none-zero intensity between
Channels 1 and 10 and sets
their level to 50% (thru-on)
Selects Channel 1 and raises
its level 50% (Note: you must
type [50], not [5])
Selects Channels 1 through 10
and lowers their levels 5%
[1] [UP] Selects Channel 1 and raises
its level 10% (as determined in
Show Options)
[1] [THRU] [10]
[DOWN]
[1] [@] [50] [@] [5]
[ENTER]
Selects Channels 1 through 10
and lowers their levels 10%
Selects Channel 1 and fades it
to 50% over 5 seconds
(NOTE: you may want to stop
reading here if you are not
interesting in advanced
command line support and
Independent Timing)
[1] [THRU] [10]
[@] [1] [-] [10]
[ENTER]
Selects Channels 1 through 10
and sets their levels to
1,2,3,4,5,6,7,8,9,10
[1] [THRU] [10]
[@] [1] [-] [10] [@]
[10] [ENTER]
[1] [THRU] [10]
[@] [50][@] [1] [-]
[10] [ENTER]
[1] [THRU] [10]
[@] [50] [@] [1] [-]
[10] [/] [10] [-] [1]
[ENTER]
Selects Channels 1 through 10
and sets their levels to
1,2,3,4,5,6,7,8,9,10 over 10
seconds
Selects Channels 1 through 10
and sets their levels to 50%.
Channel 1 will reach 50% in
1second; Channel 5 will reach
50% in 5 seconds and Channel
10 will reach 50% in 10
seconds
Selects Channels 1 through 10
and sets their levels to 50 over
11 seconds. Channel 1 will wait
1 second before fading over 10
seconds and Channel 10 will
wait 10 seconds before fading
for 1 second to 50%
Note that the [@] [+] and [@] [-] keys put the words Up and Down on the command
line. When controlling moving light attributes the [+] key puts the word Relative on
the command line whereby you can then enter positive or negative number to adjust
multiple Channels, all having different values, by the same amount. See Moving
Lights below. Even after explicitly typing levels, you can roll the Wheel to adjust
levels as described above.
101 Palette OS Operations Manual