Rack Palette - Operators Manual - Strand Lighting

Recording and Using Looks
1. Using the [ARROW KEYS] move the Blue Box to the time column you want to
change.
2. Press the [EDIT] button to put the Blue Box into edit mode.
Note:
The QWERTY equivalent of [EDIT] is [INSERT]
3. Either type in a new value to completely replace the text highlighted in blue or use
the Wheel to roll the values up or down. Each detent on the wheel will change the
value, up or down, by one second. Holding down [SHIFT] will change the value by
0.1 of a second. (For SMPTE, it is 1 second or 1 frame.)
Note:
• If you are editing a Wait/Fade time, the entire cell is highlighted in
blue. Directly typing a new value will replace both values. If
you just want to change the Wait Time, press [FULL] or [HOME] to
take you to the front of the line
(highlighting only the Wait
time). If you want to change the Fade Time, press [OUT] or [END]
likewise.
• To enter times in the HH:MM:SS format, use two dots (i.e., “ .. ”) to
make the colon. This format extends from days (DD) to fractions of a
second or frames (FF) in SMPTE time (i.e., DD:HH:MM:SS.FF). Note
that frames or the 100 th of a second appear after a single decimal
point.
4. When you are finished, press [ENTER] to close the edit box.
Tips:
To quickly edit numbers, move the Blue Box to the first cell, press [EDIT],
type in a new number, but rather than pressing [ENTER], press an Arrow
Key to move you to the next cell. The cell will automatically be open for
editing.
Note:
The Blue Box will follow the Green Light (cue running indicator) if the
Autoscroll Cue List pin is out.
Independent Timing
If you want to adjust the time of particular attributes independent of the time
specified in the cue, press [SHIFT] [EDIT] to change the Channel and Attribute grid
to the
display.
display. Press [SHIFT] [EDIT] again to return to the
Changing Multiple Cells to the Same Label or Time
1. Move the Blue Box to the first cell you want to change using the arrow keys.
2. Hold down [SHIFT]
3. Continue to press the [DOWN ARROW] or [UP ARROW] to increase the size of the
Blue Box to highlight all wanted cells
4. Let go of [SHIFT]
Palette OS Operations Manual 168