Rack Palette - Operators Manual - Strand Lighting

General Information
o
While in the main Move/Copy dialog box, if you press
[SHIFT], the Attribute button will look like
this
following:
and the softkeys will change to the
Pressing any of these changes the attribute masking without the need
to open the Attribute dialog box. You can also double tap any attribute
family to solo it.
Cues
To move or copy a cue, move the Blue Box to the desired cue. You can select more
than one cue at a time. Launch the command and press the [CUE] button or [S11]
to open the dialog box to the Cue tab:
By default, the destination Cue List is the same as the selected one, but you can
change that by pressing [S1]. When you enter the dialog box, the First Cue
Number is highlighted allowing you to just type a new number and pressing
[ENTER]. If desired, you can use [S5] New Cue Increment and change the
[S4]Cue Increment so the new cues follow a specific numbering scheme rather
than the original offsets.
If the destination cue numbers already exist, you will be presented with this dialog
box:
Cue State
If you Move or Copy a Cue with the Cue State option checked, Palette figures out
which channels and attributes have been used in this cue list up to the source cue,
243 Palette OS Operations Manual