5. Commands and Functions - Sanyo Denki America, Inc.

5. Commands and Functions
Command Code: 86 (56h)
Point Store
Data Length: Depends on the command
DAT No Function Setting range Setting unit
DAT1 Point number 0 to 7Fh -
DAT2 Direct command to be stored Direct command -
DAT3 and Depends on the command in DAT2 Depends on the command -
above
Stores a direct command to the specified point number. The data length depends on the direct
command being stored.
Transmitted data format:
Packet Length Address Command code (56h) Point No Direct command code Data (n bytes) Checksum
Command Code: 87 (57h)
Data Length: Depends on the command
Program store
DAT No Function Setting range Setting unit
DAT1 PRG No When PRG No.=1: 0
When PRG No.=128: 0 to 7F
When PRG No.=32: 0 to 1F
DAT2, 3 Line number When PRG No.=1: 0 to 3FFh
When PRG No.=128: 0 to 7
When PRG No.=32: 0 to 1Fh
DAT4 Command code to be stored Direct command (20h to 4Fh)
Program command (60h to 6Dh)
DAT5 Depends on the command in DAT4 Depends on the command
Stores a direct command line by line to the specified program number. The data length depends on the
direct command being stored.
Transmitted data format:
Packet
Address
Command
PRG
Line number
Line number
Store
Data
Checksum
Length
(57h)
No.
(lower)
(higher)
command
(n bytes)
5-35