standard operating procedure college station fire department
standard operating procedure college station fire department
standard operating procedure college station fire department
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ICM\FIREHAWK: Place the ICM in a motionless position for approximately 18 seconds, the ICM will go into full alarm approximately 12 seconds later. Press the Mode button (the green button on<br />
the upper left of ICM) once for Illumination Mode and twice for time remaining at current breathing rate (will display 3 dashes). Crack the bypass valve (red knob on Firehawk regulator) slowly to<br />
bleed off pressure until the ICM alarm gauge needle drops below 1175 psig (the beginning of the red zone on the ICM gauge) The ICM alarm and the audi-alarm bell will ring until the pressure is less<br />
than 200 psig. Press yellow reset button twice to power down ICM.<br />
CLEAN AND READY FOR SERVICE: self explanatory<br />
HAVE A GOOD DAY!<br />
RESERVE WEEKLY CHECK (MONDAY)<br />
CSFD SELF CONTAINED BREATHING APPARATUS<br />
MONTHS (4) / YEAR: _____________________________________________________________________ SCBA INVENTORY # ____________________<br />
APPARATUS / LOCATION : __________________________________________________________________<br />
OKAY = ü<br />
PROBLEM = X<br />
DATE CHECKED<br />
MONTH/DAY<br />
PERSON DOING INSPECTION INITIAL UNDER CHECKED BY:<br />
CHECKED BY:<br />
CYLINDER PRESSURE<br />
MIN. 4200 PISG<br />
BACKFRAME AND<br />
HARNESS<br />
CYLINDER<br />
ASSEMBLY<br />
ICM\FIREHAWK<br />
CLEAN AND READY<br />
FOR SERVICE<br />
REPORT ANY PROBLEMS TO YOUR OFFICER / HAVE THE SCBA TAKEN OUT OF SERVICE IF NECESSARY<br />
DATE/COMMENTS:<br />
____________________________<br />
___________________________________<br />
___________________________________<br />
___________________________________<br />
___________________________________<br />
rev: 4/94, 3/99
Change language