Toshiba iES32 Installation Manual.pdf

Installation
Important!
TTS requires a D/41ESC voice board. If your system does not already have one
installed, see “Install D/41ESC Voice Board” on page 13-12 for installation
instructions.
Step 1: Stop Stratagy Enterprise Server/Configure Manual
Start
2. Click Stop. The screen displays “Stop Pending” and then “Stopped.”
3. Click Manual.
4. Click Close.
Step 2: Note Dialogic Settings
Text-to-Speech (TTS)
1. Click the StartStratagy icon on the desktop. The Stratagy Enterprise Server Control screen
displays.
If TTS is being installed on an already existing Stratagy ES, it is necessary to uninstall and then
reinstall Dialogic software to enable TTS components. This step is in preparation for those
procedures.
Installation
Note If you have GammaLink Fax installed, you must stop the GammaLink service first and
return to this step.
1. From the Windows NT, click Start > Programs > Dialogic System Software > Dialogic
Configuration Manager - DCM. The DCM Main screen displays.
2. From the Main menu, click Service >
Startup Mode (shown at right).
3. If system is set to Automatic, click
Manual.
4. Click Stop Service. A message pop-up
box displays stating that the Service has
been successfully stopped and the
Service Status at the bottom of the
screen changes to Stopped.
5. Click OK. The message box closes.
6. Double-click on each device and make a note of its BLT address, BLT Interrupt, and ISA Bus
Width.
Note Since you are going to uninstall this software, you’ll use this information at the end of the
installation procedure for reconfiguring the voice boards.
7. Click File > Exit. The DCM Main screen closes.
4517
Text-to-Speech (TTS)
Step 3: (Optional) Install D/41ESC
➤ If your Stratagy ES does not already have a D/41ESC board installed, see “Install D/41ESC
Voice Board” on page 13-12 for instructions.
Stratagy ES I&M 06/02 10-3