Toshiba iES32 Installation Manual.pdf

Voice and Resource Board Installation
ProLine/2V Voice Board
JP6 JP5
SW1
JP1
JP7
1 2 3 4
Memory
segment
Jumper
JP6
Jumper
JP5
JP6 and JP5 viewed from
top edge of ProLine/2V
D000 No No
A000 1 No No
B000 1 Yes Yes
C000 2 Yes No
Be aware of possible conflicts with devices that often use these segments:
13. video adapters
14. disk controller BIOS and VGA BIOS
Figure 13-3 JP5 and JP6 Jumper Settings
4. Offset Address – Using the SW1 DIP switches 1, 2 and 3, set the offset address for the
ProLine/2V board. The default is 0000H.
Important! Each board in the Stratagy ES must have a unique offset address for the system to
communicate with the board. Do NOT duplicate offset addresses.
If you need to change the offset address, set the switches as follows:
Offset Address (hex)
SW1: Switches
1 2 3
0000 1 (default) Off Off Off
2000 1 Off Off On
4000 1 Off On Off
6000 1 Off On On
8000 On Off Off
A000 On Off On
C000 On On Off
E000 On On On
1. Base memory address B000H does not support offset addresses 000H~6000H.
13-4 Stratagy ES I&M 06/02