Toshiba iES32 Installation Manual.pdf

Voice and Resource Board Installation
T1 Voice Boards
Note
The connectors can only fit together one way. If the connector does not go on easily, turn it
around.
6. Attach the cable to the next board(s). If the cable has extra connectors or loose cable, tuck the
cable down and out of the way.
Note
Both ends of the cable must be used. Connectors between boards do not have to be
connected.
7. If this is a new Stratagy ES installation, go to Step 3: Complete Stratagy ES Hardware Setup
on page 2-8 to continue the system installation procedure
...or if you are adding a new board(s) to an existing system, proceed to “Configure Antares
Board for ASR” on page 13-30 or “Configure Antares Board for ASR” on page 13-30 to
configure the board(s) you just added.
T1 Voice Boards
The following T1 boards are available for installation in the Stratagy ES:
• Dialogic SingleSpan boards (D/240SC-T1, D/240PCI-T1) providing 24 voice ports.
• Dialogic DualSpan board (D/480SC-2T1) providing 48 voice ports.
D/240SC-T1 Voice Board
The D/240SC-T1 (see Figure 13-18 and Table 13-7) supports up to 24 voice ports, has a 120-Ohm
end connector and installs in an ISA bus slot.
P4 XTERM SW100
4683
Figure 13-18
D/240SC-T1 card
Table 13-7
D/240SC-T1 Parts Description
Part
P4
XTERM
SW100
Function
SCbus connector
Terminator socket for PEB
Switch to set the board ID number
13-18 Stratagy ES I&M 06/02