28.06.2015 Views

Toshiba iES32 Installation Manual.pdf

Toshiba iES32 Installation Manual.pdf

Toshiba iES32 Installation Manual.pdf

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Voice and Resource Board <strong>Installation</strong><br />

T1 Voice Boards<br />

Install D/240SC-T1 Voice Board<br />

1. Port Address – Set the board identification number by turning the rotary switch SW100 (see<br />

Figure 13-18) to one of the 16 board ID settings: 0~9, A~F. If more than one T1card is being<br />

used in the Stratagy ES, it is recommended you set the board ID sequentially, in ascending<br />

order.<br />

Important! Each board in the Stratagy ES must have a unique ID number for the system to<br />

communicate with the board. Start with the lowest number possible (i.e., 0) and do<br />

NOT duplicate ID numbers.<br />

Voice and Resource<br />

Board <strong>Installation</strong><br />

CAUTION! If you find a PEB Terminator on the board’s XTERM Socket (Figure 13-6),<br />

remove it. The board in SCbus mode is terminated internally and does not<br />

require a terminator. If left on the board, the terminator causes the board to not<br />

function properly in the Stratagy ES.<br />

2. Select an empty ISA bus slot. Remove the slot’s retaining screw and access cover plate. Keep<br />

the cover plate for possible future use.<br />

3. Insert the board’s edge connector into the slot. Press firmly until the board is securely seated in<br />

place. Replace and tighten the retaining screw.<br />

4. (Optional) To connect the D/240SC-T1 board to other SCbus boards in the system, plug the<br />

SCbus cable into the P4 connector (Figure 13-7).<br />

Note<br />

The connectors can only fit together one way. If the connector does not go on easily, turn it<br />

around.<br />

5. Attach the cable to the next board(s). If the cable has extra connectors or loose cable, tuck the<br />

cable down and out of the way.<br />

Note<br />

Both ends of the cable must be used. Connectors between boards do not have to be<br />

connected.<br />

6. Repeat this procedure for each D/240SC-T1 board you are installing.<br />

7. If this is a new Stratagy ES installation, go to Step 3: Complete Stratagy ES Hardware Setup<br />

on page 2-8 to continue the system installation procedure<br />

...or if you are adding a new board(s) to an existing system, proceed to “D/240SC-T1 Voice<br />

Board” on page 13-18 to configure the board(s) you just added.<br />

Stratagy ES I&M 06/02 13-19

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!