Toshiba iES32 Installation Manual.pdf

Voice and Resource Board Installation
GammaLink Fax Board
Table 13-5
GammaLink Fax Base Board Parts Description
Part
SW1 Switch Block
XTERM
P100
UA1~UA3
UB1~UB3
UC1~UC3
UD1~UD3
UE1~UE3
UF1~UF3
Function
Four DIP switches. Specifies which I/O ports the board uses when
communicating with the host processor. The switch also defines I/O ports for the
SC2000 and its FPGA configuration register.
Terminator socket for PEB bus mode operation.
Connector for SCBus.
Fax Cell A
Fax Cell B
Fax Cell C
Fax Cell D
Fax Cell E
Fax Cell F
Voice and Resource
Board Installation
Install GammaLink Fax CP-6/SC Board
1. I/O Address – Verify the four DIP switches on the SW1
block switch are in the default position of Off (Figure
13-14). This sets the I/O address to “0.”
If a DIP switch is not in the Off position, use a ballpoint
pen or a small screwdriver and gently move the switch to
the Off setting.
Each I/O address represents six physical-channel
hexadecimal addresses. For example, I/O address 0 is
350, 360, 370, 250, 260, and 270.
ON
1 2 3 4
3804
Bracket
Figure 13-14 SW1 Switch Settings
Note
See the GammaLink Fax Installation Guide that came with the board for settings for
additional boards.
CAUTION!
If you find a PEB Terminator on the
board’s XTERM Socket (Figure 13-15),
remove it. The board in SCbus mode is
terminated internally and does not
require a terminator. If left on the board,
the terminator causes the board to not
function properly in the Stratagy ES.
Network Module
Configuration
XTERM
Socket
Resource Module
Configuration
4752
Figure 13-15
XTERM Socket
2. Select an empty expansion bus slot. Remove the slot’s retaining screw and access cover plate.
Keep the cover plate for possible future use.
3. Insert the board’s edge connector into the slot. Press firmly until the board is securely seated in
place. Replace and tighten the retaining screw.
4. Repeat this for each GammaLink Fax board you are installing.
Stratagy ES I&M 06/02 13-15