Toshiba iES32 Installation Manual.pdf

Maintenance and Upgrades
Add Tape Drive
Notes
• Only install this software if Stratagy ES is running on Windows NT Workstation.
• The Seagate Backup Exec Software that is shipped with the Tape Stor 8 tape drives is only
supported on Windows NT Workstation.
• This software is not required to perform backups of the Stratagy ES. Windows NT has its own
backup utility (see “Backup” on page 16-2).
Step 3: Configure the Drive
➤ Since the tape drive will be on same cable as the CD-ROM drive, you do not have to change the
default jumper setting (Slave). See Figure 2 on the TapeStor 8GB Easy Installation Sheet.
Step 4: Assemble the Drive Package
1. Attach a mounting bracket to the side of the
bezel. There are two tabs on each bracket that fit
into the slots on the bezel. Push the bracket into
the bezel until you hear the tabs snap into place
and lock (see Figure 16-2). Repeat the process
with the second bracket.
Slide bracket onto bezel.
Tab A on the bezel fits
into Slot A on the bracket.
Tab B on the bottom of the bezel
fits into Slot B on the bracket.
Push until both tabs lock in slots.
4654
A
A
B
B
Figure 16-2 Bezel/Bracket Assembly
2. Place the tape drive onto the mounting brackets and line up the screw holes of the bracket and
drive (see Figure 16-3). Secure the drive to the brackets with the screws provided.
4651
Figure 16-3 Tape Drive and (Optional) ES96 Side Rail Assembly
Note
The Stratagy ES80 tape drive assembly does not require side rails. Go to Step 5: “Mount
the Drive”.
16-10 Stratagy ES I&M 06/02