2 - TCA spa

SECTION SERIES APPLICATION RANGE PAGE1CEBLIn-line or cylindermounted BoomLocvalves incorporating1CPB(D) cartridgeand additional reliefcartridge element.TYPICAL CIRCUIT EXAMPLESThese overcentre valves aresuitable for use on the boom anddipper cylinders of an excavator tohelp the manufacturer or usercomply with standard ISO8643.400 bar(5800 psi)550 litres/min(145 US GPM)6-400to6-49161CEEMANLIFTLoad holding and load safety provided by dualovercentre valves protecting the operator from hosefailure and giving him a smooth ride.1CEEWHEEL MOTORDual overcentres preventing load runaway intransmission systems forward and reverse.1CEM1CEBBRDRVPILOTPROPORTIONAL CONTROLBalanced valves are required where back pressuresvary as above in proportional valve circuits where flowis metered in and out of the directional control valve.WINCHSmooth lowering and soft stop for winches usingovercentre combined with brake shuttles for springapplied brakes.ADJUSTMENTSThe adjustment range and Max setting figures shown throughout this catalogue give the design range for each valve,higher or lower values may be attainable but should not be used without first contacting our Engineering department.Setting must ALWAYS be carried out using an appropriate gauge and it must NOT be assumed that screwing an adjusterto its maximum or minimum position will yield the maximum or minimum stated design setting for that valve.Integrated Hydraulics LtdIntegrated Hydraulics IncCollins Road, Heathcote Ind. Est., Warwick, CV34 6TF, UK.7047 Spinach Drive, Mentor, Ohio 44060, USATel: +44 (0) 1926 881171 Fax: +44 (0) 1926 315729 Tel: (440) 974 3171 Fax: (440) 974 3170Website: www.integratedhydraulics.comWebsite: www.integratedhydraulics.com6-102.F