2 - TCA spa

1CEBD SERIES OVERCENTRE VALVEFULLY BALANCED - PILOT ASSISTED1CEBD90POPPET RELIEF1VALVE (2)PILOT (3)VENT3CYL (1)4 26APPLICATIONOvercentre valves give static and dynamic control ofloads by supplying a counterbalance pressure to theactuator. They will stop runaway in the event of hoseburst and hold the load with minimal leakage.The pressure balanced overcentre relief setting isunaffected by back pressure, enabling the valve to stayopen when the valve port pressure rises. This willallow service line reliefs to work normally and will alsoallow the control of regenerative or proportionalsystems.The overcentre valve should be mounted either into,onto or as close to the actuator as possible, using amachined cavity into the actuator or a suitablemachined body, either gasket or line mounted.Single overcentre valves are normally used when theload is unidirectional, for example an aerial platform orcrane and dual overcentre valves are used forcontrolling loads in both directions for motorapplications or for cylinders going over centre.PILOT RATIOS4:1 Best suited for applications where the loadvaries and machine structure can induceinstability.Other ratios available upon request.SPECIFICATIONSFigures based on: Oil Temp = 40°C Viscosity = 40 cStRated FlowMax SettingCartridge MaterialBody Material90 litres/min (23 US GPM)Max Load InducedPressure: 270 bar (4000 psi)Relief Setting: 350 bar (5000 psi)Working parts hardened and groundsteel. External surfaces zinc platedStandard aluminium (up to 210 bar*)Add suffix ‘377’ for steel optionOPERATIONThe check section allows free flow into the actuatorthen holds and locks the load against movement. Thepilot assisted relief valve section will give controlledmovement when pilot pressure is applied. The reliefsection is normally set to open at a pressure at least1.3 times the maximum load induced pressure but thepressure required to open the valve and allowmovement depends on the pilot ratio of the valve. Foroptimisation of load control and energy usage, achoice of pilot ratios is available.The pressure required to open the valve and startactuator movement can be calculated as follows:Pilot Pressure = (Relief Setting) - (Load Pressure)Pilot RatioFEATURESCartridge is economical and fits simple cavity. Allowsquick, easy field service - reduces down time.Integrated Hydraulics LtdMounting PositionCavity NumberTorque Cartridgeinto CavityWeightSeal Kit NumberRecommendedFiltration LevelOperating TempLeakageNominal ViscosityRangeUnrestrictedA12196 (See Section 17)60 Nm (44 lbs ft)1CEBD90-20°C to +90°C5 to 500 cSt0.29 kg (0.63 lbs)SK634 (Nitrile) SK634V (Viton)SK634P (Polyurethane/Nitrile)BS5540/4 Class 18/13(25 micron nominal)0.3 millilitres/min (5 dpm)*For applications above 210 bar please consult our technical department or use the steel body option.Integrated Hydraulics IncCollins Road, Heathcote Ind. Est., Warwick, CV34 6TF, UK.7047 Spinach Drive, Mentor, Ohio 44060, USATel: +44 (0) 1926 881171 Fax: +44 (0) 1926 315729 Tel: (440) 974 3171 Fax: (440) 974 3170Website: www.integratedhydraulics.comWebsite: www.integratedhydraulics.com6-173.F