Symantec™ Security Gateways Reference Guide - Sawmill

Log messagesInformational messages (100-199)143120 - Failed to send NAT keep-alive messageDescription: If this message appears every few hours it does not indicate a problem. However, if this message appears ingreater frequency (every 10 minutes or sooner), it indicates a possible internal problem. Customers with acurrent support agreement may contact Technical Support by phone or online at http://www.symantec.com/techsupp/.120 - Found invalid configuration attribute of basic typeDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.120 - Found matching informationDescription: The component has found the information for which it was searching and this information is listed in theparameters.120 - Incomplete queryDescription: Received an incorrectly formatted DNS query. It has been dropped. The sender of the query needs to send avalid query.120 - Installed new fileDescription: The HTTP daemon has successfully installed the latest httpratings.db file.120 - Interface list contains only loopback address. Please check your TCP/IP configurationDescription: Unable to find an IP address that is operative. A misconfiguration has occurred.120 - Invalid configuration mode identifier, expectedDescription: A failure occurs during client tunnel negotiation. This does not happen frequently, but if it does, try toreconnect.120 - Invalid identifierDescription: The security gateway Phase I ID, also called the remote Phase I ID, is the identifier that lets Phase Inegotiations proceed. In this case, the security gateway Phase I ID is invalid.120 - Invalid number of transformsDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.120 - Invalid operationDescription: This message indicates a problem in one of the software components.120 - Invalid peer certificate (does not contain peer ID)Description: To configure the Symantec Client VPN to use a certificate, you must have a profile, password and thesecurity gateway Phase1ID. In this case, the peer Phase 1 ID is invalid. Contact your system administratorto ensure connectivity using certificate authorization.