Symantec™ Security Gateways Reference Guide - Sawmill

Log messagesWarning messages (300-399)193301 - Security policy uses transport mode VPN policy. Remote entity and security gateway musthave the same IP addressDescription: This indicates a misconfiguration.301 - Send bullfrog command X failed with local error YDescription: An attempt to send a command X to the bullfrog daemon failed, with a local error Y. This error is caused bytimeout while waiting for a response from the bullfrog daemon.301 - Send bullfrog command X failed with remote error YDescription: An attempt to send a command X to the bullfrog daemon failed, with a remote error Y. Ignore the error ifthe command X is 13 (Get Node Status) and remote error Y is a non-zero value.301 - Send of local file failedDescription: Unable to send file because of communication errors.301 - Setrlimit (RLIMIT_NOFILE) failedDescription: Setting user specified RLIMIT_NOFILE has failed. The default value is used.301 - Setsockopt failsDescription: A device has failed during the startup procedure. This does not happen usually, but if it does, you shouldidentify and rectify the problem.301 - Setting path MTU to 68Description: The Path maximum transmission unit (MTU) for a tunnel was set to 68. This message should not appear.301 - Shared key must be at least 20 charactersDescription: This is a configuration error where the user interface (UI) is not generating the configuration file correctly.Someone may have edited the configuration files by hand or a configuration file is corrupted. You shouldmake modifications in the UI, and then activate the new configuration.301 - Source routing was on and is now offDescription: (Microsoft Windows only) This message provides information on the status of the network checkconducted.301 - Spawn failedDescription: Attempts to run a process have failed. The administrator needs to check the parameters to identify theproblem.301 - SRL is not enabled for this clientDescription: You can restrict source addresses from which a user can establish a secure remote login (SRL) session. Inthis case, the user has attempted to connect from an address that has not been configured, so theconnection was terminated.