Symantec™ Security Gateways Reference Guide - Sawmill

192 Log messagesWarning messages (300-399)301 - Remote security gateway is not IKE enabledDescription: The tunnel is not IKE enabled. This check is done by the User Interface.301 - Repeated:Description: Messages that have occurred multiple times have been consolidated, indicating a possibility of anoccurrence of a more serious problem.301 - Requested (RLIMIT_NOFILE) value not in valid rangeDescription: The rlimit_nofile value specified in config.cf is not within the range allowed by the system, and so is notused.301 - Second pass found no valid rulesDescription: Gwcontrol attempts to authorize a connection and performs two passes through the rules. Both thesepasses fail and the connection is not allowed.301 - Security gateway is not IKE enabled, so security policy (tunnel) will not be loadedDescription: The configuration file is corrupted. To correct this problem, reconfigure and save the information.301 - Security gateway is not local, so security policy (tunnel) will not be loadedDescription: The configuration file is corrupted. To correct this problem, reconfigure and save the information.301 - Security gateway is not remote, so security policy (tunnel) will not be loadedDescription: The configuration file is corrupted. To correct this problem, reconfigure and save the information.301 - Security gateway specified for user or user group entity. The security gateway field does notapply to these entity typesDescription: This message is a warning about a bad configuration. This does not affect any operation.301 - Security gateway will not be loadedDescription: This is a configuration error where the user interface (UI) is not generating the configuration file correctly.Someone may have edited the configuration files by hand or a configuration file is corrupted. You shouldmake modifications in the UI, and then activate.301 - Security policy (tunnel) template was partially loadedDescription: The configuration file is corrupted. To correct the problem, reconfigure and save the information.301 - Security policy (tunnel) template will not be loaded as it did not generate any valid policyinstancesDescription: The configuration file is corrupted. To correct the problem, reconfigure and save the information.301 - Security policy uses transport mode VPN policy. Local entity and security gateway must havethe same IP addressDescription: This indicates a misconfiguration.