Symantec™ Security Gateways Reference Guide - Sawmill

222 Log messagesWarning messages (300-399)343 - Timeout waiting for response from paging systemDescription: The paging system did not respond in a timely manner. This notification is not sent.343 - Tried to fetch the zone, but was disallowedDescription: A client is denied access to domain information in the gateway because the administrator disallows usersto access such information.343 - Tunnel ignored because both gateways are localDescription: An attempt to add a tunnel to the tunnel database was rejected because both end points are on the samesecurity gateway. This is a configuration error.343 - Tunnel ignored because it is neither a gateway or localDescription: An attempt to add a tunnel to the tunnel database was rejected because one endpoint of the tunnel does notterminate at the security gateway. This is a configuration error.343 - Tunnel is being deletedDescription: An attempt to restore the security gateway configuration has failed because of a bad configuration entry.343 - Two NAT pools have overlapping NAT address rangesDescription: Conflicting NAT definition is found. Remove this conflicting information.343 - Two security gateways have the same IP address, so neither will be loadedDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.343 - Unable to allocate NAT address for client, so connection will be deniedDescription: Unable to allocate NAT address for the client as the NAT pool is small.343 - Unable to connect to serverDescription: This message is from the Notify daemon or TAC plus authentication. The parameters identify the serverwith which it was attempting to establish a connection. If this message is from the Notify daemon, a mailnotification is not sent.343 - Unable to create marker fileDescription: Unable to create the file, which is used to maintain the state of the security gateway.343 - Unable to determine interface for destination address. Is the system local and down? Testconnectivity with pingDescription: Unable to determine the interface for the destination address, which is because the system is local and isdown. Use the ping command to check if the connection is successful.343 - Unable to get modem attributesDescription: The notify daemon is unable to get the modem attributes. Check the configuration of the paging device.