Symantec™ Security Gateways Reference Guide - Sawmill

240 Log messagesError messages (400-499)401 - No address for trap command, so line ignoredDescription: You have to specify an address for the trap command.401 - No address, so line ignoredDescription: An address has to be specified.401 - No applicable rules found, yet rule was still selectedDescription: This is an internal error.401 - No memory resources for acceleratorDescription: Insufficient memory available for the accelerator operation.401 - No server suitable for synchronization foundDescription: A server that runs the NTP protocol is required for synchronization. Try specifying a different server.401 - No spare minor raw packet devicesDescription: There are no available slots to support proxies that contact the driver through raw packet interfaces on SunSolaris.401 - No value for clientlimit command, so line ignoredDescription: You have to specify a value for the clientlimit.401 - No value for setvar command, so line ignoredDescription: You have to specify a value for the setvar command.401 - Not enough MAC buffers preallocatedDescription: Insufficient memory available for the accelerator operation.401 - NTP user interface routines not configured in this kernelDescription: The NTP user interface routines are not available with the current kernel. A modified kernel may havebeen introduced.401 - Open event failedDescription: This is a HTTP protocol error, and it indicates a security gateway resource problem that the administratorcan rectify.401 - Opts failedDescription: A gwcontrol setsockopt command failed.401 - Out of memoryDescription: Memory could not be allocated to perform the requested function.