Symantec™ Security Gateways Reference Guide - Sawmill

248 Log messagesError messages (400-499)411 - Unable to open notify scheduleDescription: The notification configurations are corrupt. Delete these configurations and add them again.412 - Failed to parse module lineDescription: The hotfix utility encountered a problem while attempting to read one of the module sections of the hotfixcontrol file. Check previous log messages to determine the cause of the failure.412 - Unrecognized transportDescription: The notify daemon is unable to send a notification with the specified transport. The transport must be oneof the following: Mail, Pager, SNMP, Blacklist (Symantec Gateway Security) or Audio. Check the notificationwindow in the SGMI.413 - Have configuration file errors but continuingDescription: Gwcontrol determined that the current configuration file has errors. Gwcontrol is ignoring the currentconfiguration file, and continuing with the old configuration.414 - Cannot determine source IP address. Source IP will not be blacklistedDescription: The notify daemon has detected a condition, which normally would cause the source IP address to beblacklisted, but as the source IP address is not specified, it does not get blacklisted.414 - Invalid blacklist message (cannot determine source port)Description: The notify daemon has detected a condition, which normally would cause the source IP address to beblacklisted but as the source ports cannot be determined, it does not get blacklisted.414 - Invalid blacklist message (cannot determine destination IP address)Description: The notify daemon has detected a condition, which normally would cause the source IP address to beblacklisted but as the destination IP address cannot be determined, it does not get blacklisted.414 - Invalid blacklist message (cannot determine destination port)Description: The notify daemon has detected a condition, which normally would cause the source IP address to beblacklisted, but as the destination port cannot be determined, it does not get blacklisted.414 - Invalid blacklist message (Cannot determine source or destination IP addresses)Description: The notify daemon has detected a condition which normally would cause the source IP address to beblacklisted, but as the source or source IP address cannot be determined, it does not get blacklisted.414 - Invalid blacklist message (Cannot determine password)Description: The notify daemon has detected a condition which normally would cause the source IP address to beblacklisted, but as the password cannot be determined, it does not get blacklisted.420 - Unable to send to the ACE serverDescription: The SDI library could not send data to the ACE server. The server is down or inaccessible.