Symantec™ Security Gateways Reference Guide - Sawmill

Log messagesWarning messages (300-399)209343 - Failed to reloadDescription: Failed to reload the IKE tunnel configuration. One of the components is unavailable.343 - Failed to remove fileDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.343 - Failed to restartDescription: Unable to restart a proxy, management daemon, or security gateway service.343 - Failed to restore configuration from fileDescription: An attempt to restore the configuration file has failed. The resource parameter identifies name of therestore configuration file. The interim files are deleted.343 - Failed to send dataDescription: A remote access was attempted, but failed, because of a communication error.343 - Failed to stopDescription: Unable to restart a proxy, management daemon, or security gateway service.343 - Filter is not definedDescription: An attempt to restore the security gateway configuration has failed because of a bad configuration entry.343 - 'forward_to' directive found in public hosts fileDescription: The “forward to” directive was found in the hosts file.343 - Forwarding on, but server refuses to do recursionDescription: Forwarding the queries to another server continues but that server is not configured correctly.343 - Found users with = , so denying accessDescription: Authentication for this user failed because the user attribute key for this user, was set to the valueindicated in the log message.343 - Found extra directives at end of NAT configurationDescription: The nat.cf file is corrupted.343 - French client cannot connect to non-french security gatewaysDescription: Remlog sends this message when a french client is unable to connect to non-french security gateways.343 - Group contains the following unresolvable name(s)Description: A non-existent rule to referred to by a group.