Symantec™ Security Gateways Reference Guide - Sawmill

190 Log messagesWarning messages (300-399)301 - Invalid IP address or mask for hostDescription: This is a configuration error where the user interface (UI) is not generating the configuration file correctly.Someone may have edited the configuration files by hand or a configuration file is corrupted. You shouldmake modifications in the UI, and then activate the new configuration.301 - Invalid IP address or mask for subnetDescription: This is a configuration error where the user interface (UI) is not generating the configuration file correctly.Someone may have edited the configuration files by hand or a configuration file is corrupted. You shouldmake modifications in the UI, and then activate the new configuration.301 - Invalid IP compression transform IDDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.301 - Invalid number of transformsDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.301 - Invalid opcode receivedDescription: The user failed to authenticate.301 - Invalid Phase 1 IDDescription: An attempt to restore the security gateway configuration has failed because of a bad configuration entry.301 - Invalid Phase 1 ID type for security gatewayDescription: This is a configuration error where the user interface (UI) is not generating the configuration file correctly.Someone may have edited the configuration files by hand or a configuration file is corrupted. You shouldmake modifications in the UI, and then activate the new configuration.301 - Invalid port numberDescription: The port number provided to this service is not valid (non-numeric).301 - IP routing changedDescription: (Microsoft Windows only) This message provides information on the status of the network checkconducted.301 - Line too long for MAXDescription: The lines in the Out of Band Authentication (OOBA) HTML pages are too long for the internal buffers.301 - Local security gateway is not IKE enabledDescription: This message indicates that the tunnel is not IKE enabled. This check is usually done by the User Interface.