Symantec™ Security Gateways Reference Guide - Sawmill

Log messagesCritical messages (600-699)263610 - Cannot store ISAKMP security association reference based on cookiesDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.610 - Cannot store ISAKMP security association reference based on peer contextDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.610 - Cannot store new tunnel IDDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.610 - Cannot use default password for .epf fileDescription: The VPN server is terminating as it is unable to use the default password for the .epf file.610 - Could not find a usable winsock.dllDescription: (Microsoft Windows only) The process was unable to communicate through TCP/IP because it was notconfigured on the security gateway.610 - Daemon is exitingDescription: Individual proxy services are exiting normally.610 - Daemonize failedDescription: An attempt to appropriately initialize the security gateway service failed. The service may not runproperly.610 - Error executingDescription: An attempt to execute a process failed. This results in a failure to start or restart a security gatewayprocess.610 - FailedDescription: This is a general error notification, and the corrective measure usually depends on what has failed. Youshould monitor the rate of occurrence of this message.610 - Failed to generate a new tunnel IDDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.610 - Failed to get a licenseDescription: The security gateway is unable to find a valid license.610 - Failed to get a list of interfacesDescription: The server is unable to get a list of security gateway interfaces and IP addresses, so it is terminating.