Symantec™ Security Gateways Reference Guide - Sawmill

Log messagesWarning messages (300-399)215343 - Name specified may not be a root nameserverDescription: While querying for root name servers, received a response from the address in the Resource parameter,which was not a root name server. The Reason parameter provides more information.343 - NAT rule was chosen, but client transparency is not possible as both the source anddestination interfaces are the sameDescription: The security gateway has been misconfigured, both the source and the destination interfaces are the same.Therefore, NAT cannot be used.343 - No authentication key provided for serverDescription: Unable to communicate with the NTP or the radius server as no authentication information is available.343 - No message prompt from paging serviceDescription: The notify daemon is unable to send paging notifications because the pager failed to conform to the pagerprotocol standard.343 - No name found for address when reverse_lookup_required=TRUEDescription: The security gateway is configured to perform reverse lookups. In this case, the security gateway performsa lookup for a server address but did not find a name, so the connection is rejected.343 - No Phase 1 proposal acceptedDescription: This is a configuration error. Check the global_IKE_policy on both sides of the tunnel.343 - No Phase 2 proposal acceptedDescription: This is a configuration error. Check the configuration of the VPN policy used for the tunnel.343 - No response received from ACE serverDescription: The ACE server has failed to respond to a request for authenticating a user.343 - No response received from ACE serverDescription: The ACE server has failed to respond to a request for authenticating a user.343 - No response received from RADIUS server when trying to authenticateDescription: This indicates a communication problem with the RADIUS server.343 - No section for the current host was found in file. This probably indicates a problem withhostnamesDescription: This message indicates that the configuration file (for example, gsp.cf, arp.cf, interfaces.cf, spoof.cf) has amissing host name or the host name does not match what is currently configured in the system. This couldindicate a problem in changing the security gateway system host name (for example, manually instead ofthrough the GUI) or the configuration file host name does not match the current system host name afterrestore.