Symantec™ Security Gateways Reference Guide - Sawmill

Log messagesError messages (400-499)245401 - Unable to timeout blacklist entry for IP addressDescription: The blacklist daemon is unable to remove an IP address from the blacklist. As a result, this IP addresscontinues to be blocked from accessing the security gateway.401 - Unexpected Telnet stateDescription: Telnet gets into an unknown state and the connection is terminated.401 - Unknown clienttype fieldDescription: A security gateway service responded to gwcontrol but the response was invalid.401 - Unknown encr_algDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.401 - Value for statsdir too longDescription: You may have to specify a shorter value for statsdir.401 - Vulture service scanning is disabledDescription: The vulture daemon is unable to run because the configuration file is bad.401 - Write failed on file descriptorDescription: An attempt to write to a socket failed.401 - Write to daemon failedDescription: An attempt to send a reconfigure event to a security gateway service failed.402 - Error parsing header lineDescription: The hotfix utility encountered a problem while attempting to read the header section of the hotfix controlfile. Check preceding log messages to determine the cause of the failure.402 - Error processing module listDescription: The hotfix utility encountered a problem while attempting to process the list of modules from the hotfixcontrol file. Check preceding log messages to determine the cause of the failure.402 - Error validating header dataDescription: The data retrieved from the header section of the hotfix control file indicates that the hotfix is not valid forthe system on which it is being installed.402 - Unable to get host by nameDescription: The RSA SecurID server could not be resolved.