Symantec™ Security Gateways Reference Guide - Sawmill

Log messagesEmergency messages (700-799)269690 - Remote security gateway not trusted (certificate does not match)Description: Attempts to synchronize the configuration across the cluster results in failed authentication.Emergency messages (700-799)Log messages in the range 700-799 indicate an emergency; gwcontrol has failed and the system will nolonger allow traffic through. Security is ensured by shutting down all network traffic through the securitygateway.701 - Cannot allocate memoryDescription: Memory could not be allocated to perform the requested function.701 - Could not create temporary directoryDescription: The eaglepath process was unable to locate or access the temporary directory.701 - Failed to extract environment variable for temporary directoryDescription: The eaglepath process was unable to locate or access the temporary directory.701 - Failed to get attributes for temporary directoryDescription: The eaglepath process was unable to locate or access the temporary directory.701 - RepeatedDescription: Messages that have occurred multiple times have been consolidated, indicating a possibility of theoccurrence of a more serious problem.701 - Quitting because of unrecoverable errors while communicating with the driverDescription: The process terminated while communicating with the driver because of unrecoverable errors.701 - Quitting because the driver could not be openedDescription: The process terminated because the driver could not be opened.701 - Temporary directory does not existDescription: The eaglepath process was unable to locate or access the temporary directory.701 - The name used for the temporary directory exists, but it is not a directoryDescription: The eaglepath process was unable to locate or access the temporary directory.702 - Quitting because of configuration errorsDescription: This message is generated by gwcontrol (the security gateway control daemon) after reconfiguration or asystem power cycle. It indicates that one or more control files contain invalid data. This could be caused byfile corruption following a system outage, but more commonly is due to illegal addresses entered for hostentities.