Symantec™ Security Gateways Reference Guide - Sawmill

148 Log messagesInformational messages (100-199)120 - Read select file descriptor was not selectedDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.120 - Read select timed out on file descriptorDescription: This message indicates an internal software error. Please contact Technical Support by phone or online athttp://www.symantec.com/techsupp/ to report this.120 - Received control messageDescription: Received a control header line in the news article.120 - Received disconnect message from security gatewayDescription: The Symantec Client VPN has received a message to disconnect from the server.120 - Received empty response, not acceptedDescription: The user authentication process failed because the user name or password field is empty. Enter a valid username or password.120 - Received notification from peer that ISAKMP security association was negotiatedDescription: The ISAKMP software on peer informs that the Phase 1 negotiation is complete.120 - Received notification from peer that PROTOCOL security association was negotiatedDescription: The local software on peer informs that the Phase 1 negotiation is complete.120 - Received Phase 1 ID differs from configured oneDescription: During tunnel negotiation, the Phase 1 ID from the peer differs from the Phase 1 ID entered duringconfiguration.120 - Received quick mode while performing extended authentication, drop it and continue withextended authenticationDescription: The VPN server receives a quick mode while performing an extended authentication, so it drops the quickmode and continues to perform an extended authentication.120 - Received unknown commandDescription: This indicates a software error.120 - Reconfiguring ISAKMP tunnelsDescription: Loading new configuration for the IKE tunnels.120 - Reconfiguring static IPSec tunnelsDescription: The configuration information for the static IPsec tunnels has changed, so the configuration must beloaded again.