Telemecanique Altivar 56 manual - Northern Industrial

Bulletin No. 50006-519-01BChapter 5 — ConfigurationDecember 1996 8 →Diagnostic ModeWARNINGUNINTENDED EQUIPMENT ACTIONForcing drive controller logic and analog outputs may cause undesired activation ofconnected equipment.Set the connected equipment to ignore the change of state.Failure to follow this instruction can result in death, serious injury, or equipmentdamage.Analog Output TestANALOG OUTPUT TESTOUT. ASSIGNMENT VAL%AO1 ------------ 0AO2 ------------ 100FORCE:0=MIN,2=FULL†, & ENT to validThis menu allows you to change the value of the analog outputs to check for goodwiring connections without affecting drive controller operation.When the Analog Output Test screen is active, all output values are forced to 0regardless of actual drive controller settings. Changes then made to the outputswill alter the setting without affecting the state of the drive controller. When youleave the Diagnostic Mode and return to Main menu, the analog outputs resumethe programmed settings in place before the test sequence.© 1996 Square D All Rights Reserved111ηττπ://νιχοντρολσ.χοm