Telemecanique Altivar 56 manual - Northern Industrial

Bulletin No. 50006-519-01BChapter 5 — ConfigurationDecember 1996 6 →Drive Configuration Menu6.1→Torque Type6.1‘TORQUE TYPEVARIABLEVARIABLE LOW NOISE†, & ENT to modify6.1‘TORQUE TYPEDRIVE RATINGVARIABLE IN = 5.8AVARIABLE LOW Imax = 8.0A†, & ENT P = 2.2kWESC To quit ENTSelect type of torque according to the application and press ENT. A window willappear showing the current and power rating of the drive controller. Confirm bypressing ENT. Display returns to the 6→Drive Configuration menu.NOTE: Changing Torque Type or Control Type (in the 7.13→ Control Type menu) resetsthe motor parameters in the 7.11→Motor Parameters menu to the factory settings.6.2→Command Type6.2‘COMMAND TYPE2 WIRE (MAINTAINED3 WIRE (IMPULSE)(start/stop control)†, & ENT to modify\ESC To quit\F1=HelpSelect 2-wire or 3-wire command. The selection affects the operation of LI1. Factorysetting is 2-wire command. See pages 68 and 68 for detailed descriptions of 2-wireand 3-wire command.6.3→Motor Power6.3‘MOTOR POWER(ATV56U41 only).75 kW/ 1 HP1.5 kW/ 2 HP2.2 kW/ 3 HP†, & ENT to modifyFor the ATV56U41 drive controller with a motor rated less than 3 hp (or 4 hpvariable torque), the 6.3→Motor Power screen can be accessed to select the powerof the motor. This screen is only available on the ATV56U41 drive controller.© 1996 Square D All Rights Reserved67ηττπ://νιχοντρολσ.χοm