Telemecanique Altivar 56 manual - Northern Industrial

Appendix A — Parameter SummaryBulletin No. 50006-519-01B7 → General Configuration Menu December 19967.2→Application FunctionsParameter Range Factory Setting DescriptionPresetSpeedsSpeedReferenceAuto/ManualControlledStopShutdownNo1 Preset speed3 Preset speeds72 Hz0-20 mA4-20 mA20-4 mAx-20 mANoYes, Logic inputNoBy Logic inputBy Frequency level0.1-72 HzBy LI /Frequency level0.1-72 HzStopping Methods:Freewheel stopFast stopDC injectionNoYesDwell time: 0.1 to 60 sBypass NoYes, Define I/ODelay time: 0.2 to 10 sSequence Time-outFault: 0.2 to 300 s.Process Time-out Fault:0.2 s to 300 s.PI Regulator NoYes, Set PointFeed BackSet Point ManualPI ParametersNo(When presetspeeds areselected, factorysettings are 5, 10and 15 Hz)Input 1 Input 20 0 Low/reference speed1 0 Preset Speed 10 1 Preset Speed 21 0 Preset Speed 34-20 mA Modification of AI2 for the type of signal.NoNoFreewheel stopNo1 sNo2 s5 s5 sNoAllows switching between AI1 and AI2by logic command. AI1 is manualreference. AI2 is automatic. See FigureA-1 and Figure A-2.Allows frequency threshold and LogicInput to work together to tailor thestopping process.Allows drive controller to dwell at lowspeed for a time adjustable between 1and 30 seconds before completelystopping.Used to run machine at full speed whenthe drive must be taken off line forservice or repair. Allows for isolation ofthe motor by means of a contactorinstalled between the drive and themotor with a special commandsequence.Used for controlling level or flow of aprocess with setpoint and feedbackinputs162 © 1996 Square D All Rights Reservedηττπ://νιχοντρολσ.χοm