Telemecanique Altivar 56 manual - Northern Industrial

Bulletin No. 50006-519-01BChapter 5 — ConfigurationDecember 1996 7 → General Configuration Menu7.2→Application Functions7.2‘APPLIC. FUNCTIONSPRESET SPEEDSSPEED REFERENCEAUTO/MANUALCONTROLLED STOP†, & ENT to selectSHUTDOWNBYPASSPI REGULATORThis function isnot compatible with:Help F1/ESC ‘ to quitUse the 7.2→Application Functions menu to assign functions to the logic inputsand outputs.The number of functions assignable is limited by the number of inputs/outputsrequired by a function (see Table 28 on page 77), the number of inputs/outputs onthe drive controller available to be reassigned, and by compatibility of the selectedfunctions (see Figure 47 on page 78). The selection of a function which is notcompatible with one already selected causes the message illustrated above toappear on the terminal screen.The drive controller has two logic inputs that can be reassigned. If more inputs/outputs are required, an I/O Extension module can be ordered. Refer to the catalog(document number VD0C06S201_) for more information.Table 28: Logic I/O Required by Application FunctionsApplication FunctionNo. of LI InputsUsed [1]No. of AI InputsUsedNo. of LO or R2Outputs UsedPreset Speeds 1 or 2 0 0Speed Reference 0 1 or 2 0Auto/Manual 1 or 2 0 0Controlled Stop 0 or 1 0 0Shutdown 0 0 0 or 1Bypass 2 0 1PI Regulator 0, 1, or 2 0, 1, 2, or 3 0, 1, 2, or 3[1] The only LI inputs which can be reprogrammed are LI3 and LI4. LI1 is fixed as Run Enable, and LI2 is fixedas Run Forward. If more inputs are required, the I/O Extension Module can be ordered. See catalog(document VD0C06S201_) for more information.© 1996 Square D All Rights Reserved77ηττπ://νιχοντρολσ.χοm