HP Operations Manager for UNIX Administrator’s Reference

Administration of the HP Operations Management Server in a Cluster Environment
The HP Operations Management Server Running as an HA Resource Group
However, there are situations in which you need the HP Operations
management server to be stopped, while all other parts of the HA
Resource Group should continue to run. In such situations, you will need
to disable monitoring manually.
To disable the HP Operations management server monitoring manually,
use the disable option:
/opt/OV/lbin/ovharg -monitor ov-server disable
When the monitoring process is disabled manually, you will be able to
stop the HP Operations management server. This will not cause the HA
Resource Group to be switched to another cluster node. The Cluster
Manager will not detect this event, because the return code of the
monitor command will still be 0.
NOTE
After you have finished the manual HP Operations management server
administration, you must restart the HP Operations management server.
To check whether the HP Operations management server runs properly,
use the following command:
/opt/OV/bin/OpC/opcsv
❏
❏
If the management server is running, enable monitoring again by
using the following command:
/opt/OV/lbin/ovharg -monitor ov-server enable
If the HP Operations management server is not running properly,
you have to perform additional manual steps in order to put it in a
running state.
450
Chapter 13