HP Operations Manager for UNIX Administrator’s Reference

Configuring HPOM
About Preconfigured Elements
❏
2. If NNM is not running on the node where you want to intercept
events, perform the following on HTTPS-based managed nodes:
Use the ovconfchg command-line tool as follows:
ovconfchg -ns eaagt -set \
SNMP_SESSION_MODE NO_TRAPD
3. Assign and distribute the trap template to the node.
Configuration to Avoid Duplicate Messages
Make certain that an HPOM agent (and thus, an HPOM event
interceptor) runs on all NNM collection stations. Use the Print
Collection Station application in the NNM Tools application group to
verify which managed nodes are set up as NNM collection stations.
Intercepting Events with Event Correlation Services
By default, opctrapi connects to the correlated event flow of pmd.
You can change this behavior by performing the following on
HTTPS-based managed nodes:
Use the ovconfchg command-line tool as follows:
ovconfchg -ns eaagt -set \
SNMP_EVENT_FLOW [CORR|RAW|ALL]
where:
CORR
Correlated event flow (the default).
RAW
Uncorrelated event flow. This flow does not contain
events created by correlations.
ALL
CORR plus RAW minus any duplicates.
The correlated event flow (CORR) is further divided into streams.
opctrapi connects to the default Event Correlation Services (ECS)
stream of pmd (default). If necessary, you can configure opctrapi to
connect to a specific ECS stream of pmd by performing the following on
HTTPS-based managed nodes:
Use the ovconfchg command-line tool as follows:
ovconfchg -ns eaagt -set \
SNMP_STREAM_NAME
Chapter 2 85