CanOBD2&1 Scan Tool - Sears

OBD2 Live Data Mode
LIVE DATA PLAYBACK
2. If the Code Reader is not connected to
a vehicle:
� With the CanOBD2&1 Scan Tool not
connected to a vehicle, press the
POWER/LINK button. The “To
Link” screen shows on the
CanOBD2&1 Scan Tool’s display.
Press the DOWN button for
instructions to view DTCs in
memory.
� Press the ENTER/LD button.
The “Select OBD System” screen
displays.
� Use the UP and DOWN
buttons, as necessary, to highlight
OBD2 Vehicle, then press the
ENTER/LD button. The display
shows the first DTC stored in the
CanOBD2&1 Scan Tool’s memory.
� Press the ENTER/LD button to
place the CanOBD2&1 Scan Tool in
"Live Data Playback" mode.
3. The display shows the recorded Live Data, beginning with the
"trigger" frame.
When you select Yes from the
Record Live Data confirmation
screen, the CanOBD2&1 Scan
Tool enters the "Live Data
Playback" mode, and the display
shows the recorded Live Data,
beginning with the "trigger" frame.
� A vehicle usually supports several PIDs, however, only a
limited amount of PID data can be displayed on the screen at
one time. If additional PID data is available, a small arrow will
be shown on the display. Use the UP and DOWN
buttons, as necessary, to scroll up or down to view all available
PID data.
� When viewing recorded Live Data, look for any irregularities in
any of the PID values/signal information (LTFT %, RPM, MAP,
TEMP, etc.). If any PIDs are not within specification, or
irregularities are detected, follow the procedures in the vehicle's
service repair manual to perform additional troubleshooting and
repair.
54 CanOBD2&1