CanOBD2&1 Scan Tool - Sears

Additional OBD2 Tests
SYSTEM TEST
� Test ID number
� Module ID number
� Component ID number
� Min or Max test limit
Only one test limit, either Min
or Max, is shown for any given
test.
� Test Value and status
Status is calculated by the CanOBD2&1 Scan Tool by
comparing the Test Value against the displayed test limit
(either Min or Max). Status is shown as either Low, High
or OK.
5. When you have finished viewing the retrieved test data, scroll to the
end of the display to select Exit, then press the ENTER/LD
button to return to the “Select Test” screen.
SYSTEM TEST
The System Test function lets you initiate a leak test for the vehicle's
EVAP system.
The CanOBD2&1 Scan Tool does not perform the leak test,
but signals the vehicle's on-board computer to initiate the
test. The vehicle manufacturer determines the criteria and
method for stopping the test once it has been started.
BEFORE using the System Test function, refer to the
vehicle's service repair manual to determine the procedures
necessary to stop the test.
1. From the "Mode Selection Menu", use
the UP and DOWN buttons as
necessary, to highlight System Test,
then press the ENTER/LD button.
� The "System Test Menu" displays.
2. Use the UP and DOWN buttons,
as necessary, to highlight EVAP Leak
Test, then press the ENTER/LD
button.
3. A "One moment please..." message
displays while the request is sent to the
vehicle's on-board computer.
64 CanOBD2&1