CanOBD2&1 Scan Tool - Sears

Ford OBD1 Systems
ADDITIONAL TESTS FOR EEC-IV SYSTEMS - WIGGLE TEST
6. Select the desired Wiggle Test from the
menu displayed.
� To perform the KOEO Wiggle Test:
- Highlight KOEO Wiggle Test.
- Turn ignition ON. DO NOT start
the engine.
- Press the ENTER/LD button
to continue.
� To perform the KOER Wiggle Test:
- Highlight KOER Wiggle Test.
- Turn the ignition ON and start the engine.
- Press the ENTER/LD button to continue.
7. A "One moment please test is in
progress" message shows temporarily
on the CanOBD2&1 Scan Tool’s display.
� If the CanOBD2&1 Scan Tool fails
to link to the vehicle's computer, a
"Vehicle is not responding" message
shows on the CanOBD2&1
Scan Tool's display. Do the following:
For KOEO Wiggle Test:
- Verify the ignition is ON.
- Turn the ignition OFF, wait 10 seconds, then turn back ON to
reset the computer. Press the ENTER/LD button to
continue.
For KOER Wiggle Test:
- Turn the engine OFF, wait 10 seconds, then turn back ON.
Press the ENTER/LD button to continue.
BE SURE to perform the added procedures in step 6, if
appropriate for your vehicle, BEFORE turning the
ignition ON.
- Press ENTER/LD button to continue.
8. If the CanOBD2&1 Scan Tool was able to link to the vehicle
successfully, a "Wiggle test is active..." message shows temporarily
on the CanOBD2&1 Scan Tool’s display. This is followed by a
message instructing you how to perform the test.
� Press the ENTER/LD
Test at this time.
button if you wish to exit the Wiggle
9. Wiggle, tap and move the suspected sensor or wiring.
CanOBD2&1 95