eWON General Reference Guide - eWON wiki

you can also activate the Serial Debug in the configuration file.
Syntax is SerDebX:Y X is the Serial port number and Y is the debug mode
General Reference Guide Monitoring Web Interface
To enable the Serial debug mode on Serial port 1, you need to send by FTP a "config.txt" file containing only:
Or you can use a little Script Basic:
As the Serial Debug uses eWON ressources (CPU and memory), don’t forget to disable the debugging once you don’t need it
anymore.
Set the SerDebX to 0 (null) to disable it.
The buffer used to store data in the real time log is limited to 500 characters, so if an RX or TX data stream is too long, an error message saying
that it is not possible to log it is logged instead
Example: SER-Rx: Too long to print (800)
If the Debug mode is >1 then the ascii values are also logged if there is enough space.
So, even if ascii debug is used, if there is no space, no ascii data are appended to the hex data.
6.7.4.4 Activate VPN debug mode
Debug mode value (Y) Description
:
:System
SerDeb1:1
0 No debug
1 Hex values Tx & Rx
2 Hex and Ascii values Tx & Rx
3
Hex and Ascii values Tx & Rx
but Rx timeouts are not logged (clearer in log)
(usefull for Modem debugging)
Table 153: Serial Debug : mode values
Setsys SYS,"load"
Setsys SYS,"SerDeb1",1
Setsys SYS,"save"
cfgsave : REM to debug also after reboot
Figure 151: Activate VPN debug
The VPN diagnosis can be set to 3 levels or disabled.
RG-001-0-EN ver 1.14 eWON® - 02/05/2012 - ©eWON sa Page 179