eWON General Reference Guide - eWON wiki

3.3.4.1.1.4 PSTN: Leased line configuration
General Reference Guide eWON Configuration
PSTN modem types MT5634SMI-xx have the ability to work in Leased Line mode.
In this mode, you are able to connect by phone two eWONs with simple wires.
The two eWONs must have a MT5634SMI-xx modem.
One side acts as the client and you must insert the LLCLT command in the init string.
The other side acts as the server and you must enter the LLSRV command in the init string.
The init string MUST start by LLCLT or LLSRV for LeasedLine mode operation but the init string can continue with other parameters.
Example:
LLSRV;AT&FE1&Q5&K3&D2&C1
Or:
LLSRV
or
LLCLT
or
...
The link is established by the CLIENT. This eWON Client can be configured with following parameters:
Note: Username and password of an user on the eWON Server.
The eWON Server can be configured with following parameters:
Modem Init String LLCLT
Call direction allowed Outgoing Only
Primary Server ' Phone number 0
Primary Server ' User Name adm
Primary Server ' Password adm
Modem Init String LLSRV
Call direction allowed Incoming Only
• When the dial-out occurs, it takes up to 2 minutes to synchronize both eWONs.
• The Server modem leased line (LLSRV) cannot generate outgoing calls, or it would generate an error.
• The Client modem leased line (LLCLT) cannot receive incoming calls.
RG-001-0-EN ver 1.14 eWON® - 02/05/2012 - ©eWON sa Page 34