eWON General Reference Guide - eWON wiki

3.3.4.5.3.4 Editing the value of a configuration parameter
To edit the value, double-click on the selected record. The edit window opens:
General Reference Guide eWON Configuration
Figure 66: Edit value window
As soon as you change the value and click OK, this value appears in the Value column of the interface. It is however not yet written in the eWON.
It will be once you click on Save (typically after having edited all the parameters you need to change).
3.3.4.5.4 Features
Figure 67: Features setup page
There is some "options/restrictions" available on the firmware. To activate these features, you need to enter an "enable code".
3.3.4.5.5 REBOOT
Figure 68: eWON REBOOT Request page from the Storage menu
If for any reason you want to restart your eWON, then you just have to click on the REBOOT button, and the reboot process will begin.
Your eWON will be accessible again when restart is completed.
For further information on the different ways to reboot the eWON, please refer to chapter "Reboot" on page 15.
RG-001-0-EN ver 1.14 eWON® - 02/05/2012 - ©eWON sa Page 73