Community Building with ChatSpace Server Manual

Using the example and the Los Angeles leaves, you would add an entry for
the Philadelphia hub below the entry for the West Coast hub.
4. In the ServerName field, enter the name of the backup hub server.
This name is the text that is listed in the Configuration Tool’s General
tab, ServerName field for the backup hub.
Following the example, the name of the Philadelphia hub would be
entered when configuring the backup hub for the Los Angeles leaves and
vice versa.
5. Check the box labeled Allow connect-out to server.
6. In the Hostname field, enter the TCP/IP host name for the server being
added to the cluster.
Continuing with the example, philadelphia.hub.com could be entered
for when configuring the backup hub for the Los Angeles leaves.
Note
Dynamic IP addresses should not be used here. If added server has a Dynamic
IP address, an unchanging hostname should be obtained from a service such as
DynDNS.
7. Check the box labeled Auto Connect.
This option allows ChatSpace to periodically attempt to connect to this
server, whenever it is currently not connected.
8. In the Password Expected field, enter the password that the backup hub
will use to access the leaf being configured.
9. In the Password Sent field, enter the password the leaf being configured
will use to access the backup hub.
10.Close the Server Connection Entry window and the ChatSpace
Configuration Tool.
Your entry is not saved until all windows of the Configuration Tool are
closed.
Repeat the above procedure for each of the remaining leaves and for the
leaves of the other hubs.
Managing the cluster
You may connect or disconnect other servers to your server if they are
defined. Only the server’s owner can set up these definitions.
To check which (if any) servers are allowed to link to your server:
23