Manual de diseño de Obras Civiles [Diseño por Viento] CFEV08

COMENTARIOS
REFERENCIAS
AIJ (2005), “Recommendations for Loads on Buildings, Chapter 6, Wind Loads”,
Architectural Institute of Japan.
ANSI/TIA-222-G-1 (2007), “Structural Standards for Steel Antenna Towers and Antenna
Supporting Structures-Addendum 1”, Telecommunications Industry Association, EIA,
April.
ANSI/TIA-222-G-2005 (2006), “Structural Standards for Antenna Supporting Structures
and Antennas”, Telecommunications Industry Association, EIA, August.
AS/NZS 1170.2:2002 (2005), “Structural design actions. Part 2: Wind actions”,
Australian Standards and New Zealand Standards, April.
BS 8100-4:1995, (2003), “Lattice towers and masts, Part 4: Code of practice for loadings
of guyed mast”, British Standards.
BS 6399-2:1997, (2002), “Loadings for buildings, Part 2: Code of practice for wind
loads”, British Standards.
BS EN 1991-1-4:2005, British Standard. Eurocode 1: “Actions on structures. Part 1-4.
General actions – Wind actions”. European Committee for Standardization.
Boggs, A. W.; Hosoya, N.; Cochran, L. (2000), “Sources of Torsional Wind Loadings on
Tall Buildings: Lesson From the Wind Tunnel”, Advanced Technology in Structural
Engineering, Proceedings of the 2000 Structures Congress and Exposition, SEI/ASCE,
May.
Buchholdt, H. A. (1999), “An introduction to cable roof structures”, second edition,
Thomas Telford.
Chen, B.; Wu Y.; Shen, S. (2006), “Wind-Resistant design of tensile membrane
structures”, Engineering Mechanics, Vol. 23, No. 27, pp. 65-71.
Chen, B.;. Wu Y.; Shen, S. (2005), “Wind-induced response analysis of conical
membrane structures”, Journal of Harbin Institute of Technology (New Series), Vol. 12,
No. 5, pp. 481-487.
4.4. II. 20