VICTRIX 75 - Saint-Roch

IE3.4 OPERATIONAL ANOMALIES WITH MANUAL RE-ARM.Code “E” “ Description Solution00 Flame presence inhibitedCheck detection electrodeCheck circuit board02 Ignition blockCheck gas valveCheck circuit boardCheck electrodes positionCheck flame signal at minimum greater than 6 μA03, 05, 06, 07, 11,13, 14, 15, 16, 17,44, 60Internal block (electronic)Check circuit boardReplace circuit board04 Non-volatile block (it occurs in the case of block and no electric power supply) Check cause of block12 Overtemperature safety thermostat intervention / 24 V fuse openingCheck circuit board fusesCheck water temperature thermostatCheck fumes thermostat18 System delivery temperature too high Check water circulation in system19 System return temperature too high Check water circulation in system25 System delivery temperature increase too fastCheck water circulation in systemCheck main heat exchanger26 Insufficient water pressureCheck for the presence of leaks in the circuitTake the system water pressure to a value between1and 1.2 bar28 Fan fault (Hall signal missing)Check fanCheck fuse “F3”Check circuit board29 Fan faultCheck fanCheck fuse “F3”Check circuit board30 Temperature difference between system delivery and return too high Check water circulation in system31 System delivery probe fault (short-circuited) Replace system delivery probe32 System return probe fault (short-circuited) Replace system return probe33 Domestic circuit probe fault (short-circuited) Replace domestic water probe36 System delivery probe fault (open) Replace system delivery probe37 System return probe fault (open) Replace system return probe38 Domestic water probe fault (open) Replace domestic water probe65 Fan fault (insufficient air delivery) Check fan functionality114 Invalid cascade addressCheck address set on card(See cascade and zone adjuster instruction book)118 Loss of ionisation current during ignition of the burner Check the gas power supply pressureE.g. if these values are given on the display itE 02 means the appliance is in ignition “block”. Toeliminate the block press the RESET buttonlocated on the boiler panel.100