Class-8 Heavy Truck Duty Cycle Project Final Report - Center for ...

can also be changed from this window.
i) If the appropriate IP appears (192.168.100.100), click on
it and press OK.
ii) If the appropriate IP address is not in the list (because,
for example, a new computer is being used or the IP address
has been changed), click Add, type in the address
(192.168.100.100), and click OK. Click on the correct
address, and click OK.
d) From the menu, select File > New Setup.
e) Select the Hardware Setup window and click Query.
f) If the software generates a list of hardware, then the setup has
been successful.
Setting the Internal Clock
Refer to Section 9.1.5. Setting the FCS Time Zone and Clock.
7.1.2. Initial VBOX Setup
NOTE: This procedure begins with all equipment and power supplies
turned off. The VBOX Tools software should be loaded, but not
opened at this time. In order to use the USB-Serial connector to
interface with the VBOX, the accompanying software must be loaded
on the support computer; standard/default Windows configurations are
inadequate.
Figure 7.1.2-1: VBOX II Lite and Accessories
D-24