Class-8 Heavy Truck Duty Cycle Project Final Report - Center for ...

Hardware Setup and Configuration. For all channel IDs, the “0” (as in
“xxxx_0”) represents the DAS number.
1) Select the Test ID / Network Setup window and click Edit ID.
2) In the Title field, type the TCE setup file name.
3) Fill in the name of the Operator.
4) The Date field will automatically show the current date.
NOTE: Whenever the Edit ID button is clicked, the date field will be
updated to the current date. If necessary, this date may be
changed by typing in the desired date.
5) In the Comments field, type in a brief description of the test
including the purpose of the test specific hardware/sensors used,
and any other notes which may be helpful to future operators.
Figure 7.2.3: Editing the Test ID
6) When finished, click OK and save the test setup file (Ctrl+S).
NOTE: Changes to the Test ID may be made at any time during the
test setup. When finished with test setup, check/update the Test ID to
verify the information it contains is still relevant to the test.
7.2.4. Transducer Channel Setup
Note: This procedure is performed following Hardware Setup and
Configuration. While the eDAQ does not need to be connected to the
computer for this step, the TCE software should be running and the
appropriate setup file (with hardware already set up) should be open
(File > Open).
D-35